Skip to content

Support



Juniper was the first North American IP routing vendor to achieve the prestigious TL 9000 certification by the Quality of Excellence for Suppliers of Telecommunications (QuEST) Forum in the router category, for design, development, provision and service and support.



What is J-Care?

It's the world-class service and support that you expect from a company that delivers the industry's best infrastructure and security products. With J-Care, you now have the confidence knowing that Juniper will do our part to keep you on top of the world!


Connecting an EX-series Switch to a Network for Out-of-Band Management

EX-series switches have an out-of-band management port with an RJ-45 connector on the rear panel. If you need to monitor and manage an EX-series switch using a dedicated management channel, you can use the out-of-band management port to connect the EX-series switch to the management device.

Ensure you have an Ethernet cable with an RJ-45 connector available. One such cable is provided with the switch. Figure 3 shows the RJ-45 connector of the Ethernet cable supplied with the switch.

To connect an EX-series switch to a network for out-of-band management (see Figure 1 and Figure 2):

  1. Connect one end of the Ethernet cable to the management port (labelled MGMT) on the rear panel of the EX-series switch.
  2. Connect the other end of the Ethernet cable to the network device.

Figure 1: Connecting an EX 3200 Switch to a Network for Out-of-Band Management

Image g020057.gif

Figure 2: Connecting an EX 4200 Switch to a Network for Out-of-Band Management

Image g020087.gif

Figure 3: Ethernet Cable Connector

Image g001063.gif