[Contents] [Prev] [Next] [Index] [Report an Error] [No Frames]

Steel Belted Radius Carrier 7.0 Installation Guide > Installing Signalware 9 > Configuring the Platform

Configuring the Platform

This group of steps configures the platform.

  1. From the Initial Install screen, enter 2 to select Configure Platform.

The Configure Platform screen is displayed.

  1. Enter 0 to accept the install directory that you entered earlier.

The Information Section screen is displayed.

  1. Press Enter to accept the default "Yes" to answer the Continue with configurePlatform procedure? prompt.

The CE Configuration screen is displayed.

  1. Enter 1. (No other entry is supported.)

The UDP/TCP Port Configuration screen is displayed. It prompts you for a UDP port value.

  1. We recommend that you press Enter to accept the default UDP port base value, but you may enter an alternate.

The UDP/TCP Port Configuration screen prompts you for a TCP port value.

  1. We recommend that you press Enter to accept the default TCP port base value, but you may enter an alternate.

A confirmation screen prompts to apply the configuration.

Press Enter to accept yes, the default.

A "configurePlatform completed successfully" message is displayed.

  1. Press Enter.

The Initial Install Screen is displayed.

[Contents] [Prev] [Next] [Index] [Report an Error] [No Frames]