Supporting SIM, WiMAX, or SS7 with Steel-Belted Radius Carrier
Steel-Belted Radius Carrier support for SIM and WiMAX depends on Signalware 9 with Service Pack 5T software being properly installed on the Solaris server. If the SBR Carrier server communicates with an SS7 device, both Signalware 9 with Service Pack 5T and a supported Ulticom SS7 communications interface board must be present on the Solaris server.
Also, if EAP-SIM or EAP-AKA authentications are used, Signalware 9 with Service Pack 5T is required.
 |
NOTE: We strongly recommend that Signalware software and the SS7 interface board, if one is used, be installed and configured before Steel-Belted Radius Carrier is installed. |
The Ulticom installation documentation is delivered with the Signalware 9 and hardware packages. For your reference, there are two chapters in Part 2, Signalware 9 Support for Steel-Belted Radius Carrier, that show an example Signalware installation with the correct settings for simple integration with Steel-Belted Radius Carrier and the details of Signalware 9 configuration files.